![]() ![]() Unapproved: This technology or standard can be used only if a POA&M review is conducted and signed by In the VA Decision Matrix is considered unapproved for use.Īpproved: The technology/standard has been approved for use.Īpproved w/Constraints: The technology/standard can be used within the specified constraints locatedīelow the decision matrix in the footnote and on the General tab. Any major.minor version that is not listed To ensure that the target version of the technology will be supported. Responsibility to consult the organizations responsible for the desktop, testing, and/or production environments These decisions areīased upon the best information available as of the most current date. The VA Decision Matrix displays the current and future VA IT position regarding different releases of a TRM entry. TRM Technology, obtained from the vendor (or from the release source). The Vendor Release table provides the known releases for the Gerber OMEGA CP (Cut/Print) OMEGA CS (Cut Solution) OMEGA Layout Station OMEGA Plot Station For additional information or assistance regarding Section 508, please contact the Section 508 Office at Decisions This technology qualifies for a legally-defined Exception (Back Office) as determined by the Section 508 Office and will not need a 508 assessment prior to being available in the TRM. Prior to use of this technology, users should check with their supervisor, Information Security Officer (ISO), Facility Chief Information Officer (CIO), or local Office of Information and Technology (OI&T) representative to ensure that all actions are consistent with current VA policies and procedures prior to implementation. Users must ensure sensitive data is properly protected in compliance with all VA regulations. Users must ensure their use of this technology/standard is consistent with VA policies and standards, including, but not limited to, VA Handbooks 61 VA Directives 6004, 6513, and 6517 and National Institute of Standards and Technology (NIST) standards, including Federal Information Processing Standards (FIPS). This assessment covers all available editions. Multiple editions are available for this technology: Gerber OMEGA CP (Cut/Print), OMEGA CS (Cut Solution), OMEGA Layout Station, and OMEGA Plot Station. ![]() This product supports vinyl cutting, printing and routing through the use of devices such as Gerber vinyl cutters, the Gerber EDGE family of thermal printers, as well as Gerber routers and flatbed cutters. Gerber OMEGA is a layout, design, output and conversion solution created specifically for use to create professional graphics such as signs, labels, decals and display graphics. More information on the proper use of the TRM can be found on the Technologies must be operated and maintained in accordance with Federal and Department security and ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |